A Guide To Install A Satellite Dish For DSTV

DSTV is a television service that provides a wide range of channels related to entertainment, news, music, sports, lifestyle, documentaries, religion and more subscribers. If you are keen to subscribe to it, you can consult the providers like the DSTV installation Centurion to enjoy unlimited fun and entertainment all day. Once you obtain DSTV installation Pretoria services, it can be useful for your children too, as there are series of knowledge and kids related channels.

Installation process of a satellite dish for DSTV

If you are determined to install or setup a satellite dish for your DSTV all by yourself, you can refer to these useful tips. When you refer to this guide and set up your satellite dishes, you can watch the channels without any interruption due to poor signal or other related issues. If you are well versed with these technicalities, it helps in fixing common issues related to satellite dishes.

Tools required for installation

Some of the basic tools required for installation of satellite dishes for DSTV include the satellite dish and its components such as the decoder, reflector, and LNBF (low noise block feed). These can be bought from the market easily. In addition, a hammer, nail, cable clips, ring spanners, electric pliers, cello tape, screwdriver and signal meter are some of the other necessary tools you should be ready with before starting the installation process. You can also seek services from DSTV Installation Centurion if you think that it’s not feasible to do it all alone.

Setting up the satellite dish

The components of satellite dish are usually available in separate parts and it has to be assembled in a manner to ensure that signals are received clearly and should be resistant to strong wind. The assembly of the components largely depends on the area you intend to mount it on. It can be mounted on a wall, root, or a wooden board. If you are planning to mount it on a pipe of the building, you have to ensure that it is well grounded and sturdy. Thereafter, you can fit in the nuts and screws in the reflector’s rear and the LNBF can be connected accordingly. Once the satellite dish has been mounted correctly, you can proceed towards the final steps.

Configuration of the active smart card, decoder and channels

The cable needs to be plugged into the LNBF base of the dish assembly and the other end of the cable should be plugged into the antenna port towards the back of the signal meter of the satellite or a sturdy decoder. Thereafter, dish alignment should be done by considering the west and east points based on the satellite provider you wish to subscribe for. The DSTV can also be installed by some of the reputed DSTV installation Pretoria companies. Once these steps are completed, you can scan the channels to activate the services. Use the remote control to find the menu option and select installation. Your satellite dish is fully ready with its setup.

The author has provided a useful guide on the procedures to Dstv installation Pretoria.