How to Connect the Power Cord of the Environmental Test Chamber

Environmental test chamber of power line equipment: zero green line, yellow green double color as ground, other colour are in front. The input power supply voltage of the machine shake ups and downs can't surpass promised size of less than, ground wire outstanding is necessary, or it will affect the machine function. It is necessary, please according to the size of the machine power equipment appropriate insurance device, in case of machine failure can safely the detection power, avoid fire attack and hurt.

Please have necessary machine in a safe space positioning after wiring, ensure the wiring together together with the rated voltage of the machine, or you'll have to get an electric shock and attack. Wiring operation personnel should be professional, to avoid damage to the machine fault fault and input power, burnt components. Please make sure the input power is in the case of a disconnect wiring again, avoid electric shock. If machines have a three-phase motor, when connected to power supply.

If necessary, please check it accurately. The environmental test chamber if it is single phase motors in the factory has adjusted the it, in the replacement, make sure it is accurate to avoid affect the machine function. Wiring end, under the condition of guarantee the machine control electric trouble-free consistent input power, at the same time before electricity is necessary all the electric box cover plate installed, or get an electric shock and fire risk.

Environmental test chamber full-time personnel can not repair and check the machine, and it is necessary to disassemble and check in the case of power failure, to avoid the attack of electric shock and fire.

It is not allowed to remove the electrical box, the door of the electrical box, the body side plate and some safety protection devices for work, which means the high-temperature constant temperature test box is in a risky operation condition, which is very risky. The main power switch on the control panel should be operated as little as possible, and the temperature switch and the user power switch should be closed when the machine stops.

In terms of the design of the environmental chamber, we give priority to the selection of good design, as well as the material. The circular inner box we used in the high-voltage accelerated aging test box conforms to industrial safety standards, which adopts the prototype of stainless steel and USES the results of the inner box. This design can prevent condensation and water dripping in the test.

In addition, the high pressure accelerated aging test chamber with the circular lining of stainless steel is selected with the circular design of stainless steel, which can completely avoid the direct impact of latent heat of steam on the test product. Lead to damage of test product.

In addition, precise design is adopted in water level control, so that each test adding water can be used for 200 hours, and the air tightness is very good, and the water consumption is very low

The pressure system in the environmental test chamber is also greatly changed. When the internal pressure increases, the high pressure accelerates the aging of the test box. The door of the test box calls for backpressure, leading to a closer combination with the box body.

In addition, automatic safety protection can be achieved at the critical point LIMIT of the high-voltage accelerated aging test box, and the indicator light will be displayed in case of abnormal reasons and faults, which can well avoid the loss caused by abnormal conditions and even damage today.