Roof Leaking And Repairing 5 Tips

With the turbulent weather we have in Oklahoma, there are times when you should be able to repair minor leaks and broken shingles yourself. Here are some tips to help you do that, as well as practical safety tips when removing a ladder.

1. Roof leaks:

Some leaks are due to minor problems - such as a single torn shingle or a small hole in the light - that you can handle with a little DIY knowledge and some basic tools. But some situations require roofing technology. If you can fix the problem quickly and completely, call a professional as soon as possible. Water damage spreads quickly, even with minor leaks. A licensed roof is best if:

There are many leaks.

Leaks enter the frames or near walls, making it difficult for you to track the source.

The fix you made is not valid.

Leaks involve extensive damage to the roof or light areas.

An attic, such as a ceramic tile roof, is beyond your ability.

2. Shingle Repair:

Here's your quick fix: Get a roof cement tube and a piece of light aluminum (available at home). Cut light that is about 1 inch shorter than torn shingle and about 4 inches long to pass under the tabs on both sides. Use the flat pry bar to carefully release the damaged tab and tabs left and right. Next, use two or three thick concrete beads for the roofing area under the shingle.

Slide the light down and use the roofing cement over the glitter. Press the tab down firmly to stick to the light on the ceiling.

3. Shingle switch:

Here is your quick fix: A typical wood-shingle house is covered with thousands of individual shingles and, over time, it is inevitable that a few will split or be damaged. To change one shingle, first use a chisel and a hammer to split it into a few narrow pieces, then pull out the forks. Slip the hacksaw blade under the shingle above and cut between the nails holding the old shingle in place. Next, use a utility knife to cut the new shingle to match the width of the space. Slide the shingle in place and tap it within 1 inch in its final position. Drive with two nails of cedar sheets in an upward position, just below the edge of the shingle waist above. Then use a wood block and hammer to press the new shingle into place. As the shingle slips into place, it will pull the nails up and back the shingle over.

4. Chimney On Your Roof:

Working on the roof is obviously dangerous. Here are some simple safety precautions you should take:

To reduce the chances of slipping and to prevent damage to the roof, climb the roof as slowly as possible.

If you are going to do a lot of work on the roof, buy or rent a roofer ladder with a roof overlap.

When on the roof, use a sturdy safety harness or seat belt attached to a fixed area as a chimney base.

Reach the roof by means of a high-quality ladder protected in the house in at least two places.

Never work on the roof under snowy conditions. Dark-colored shingles can hide snow spots.

If all of this seems to be more than just what you want to do, please consider joining Terrell's Overhead Safety Club. Our professional inspectors will "walk on your roof" every year, following our 17-point safety checklist. We will provide you with a copy of the