Make Significant Cost and Energy Savings By Choosing The Right Chiller Manufacturer For Your Busines

It is very important to buy the chiller be it screw chillers or scroll chillers from a good manufacturer since it is responsible to highest electricity in any type of manufacturing plan. You will face rise in operating expenditure to the tune of eight to ten percent in case there are problems in chiller in the form of fouled tubes, refrigerant leaks and several other similar reasons.

By purchasing a chiller whether it is screw chillers or scroll chillers from a good chiller manufacturers you can be assured about quality of product and operate it as per requirement.

Let us now look at some of the other factors which can help in proper maintenance of appliance and lead to energy as well as cost savings for your organization.

Important Factors in Chiller Maintenance

Activity Logs: The benefit of maintaining daily log is that it assists in keeping record of different operational conditions such as temperature, fluid levels, pressure and flow rates. This type of information helps in tracing out various maintenance requirements as well as assists in preventing small factors from becoming serious issues.

Upkeep of Tubes: According to chiller manufacturers one of the main factors which are used for evaluating any chiller’s performance is its effectiveness in heat transfer. Such performance can get hindered due to many different factors ranging from scaling to mineral & algae deposition and many other types of impurities.

You will be able to judge whether device is working properly and meeting heat transfer requirement by checking its approach temperature. In case you find that this approach temperature is high then it signifies that efficiency of the appliance is reducing. In such situation solution is to maintain clean condenser tubes to allow proper heat transfer effectiveness.

Treating Condenser: As per manufacturers of refrigeration equipments In case condensers have water loops which make use of open cooling sources then water treatment is essential for preventing as well as eliminating problems such as scaling and corrosion. These problems result in fouling within condenser and also obstruct proper heat transfer as well as reduce effectiveness of piping.

Temperature of Water: You would be able to increase condenser efficiency by reducing water temperature before it reaches condenser. Often it is seen that operator try to reduce set point for chilled water so as to overcome problems in air handler.

But such techniques do not offer a permanent solution. This type of method also results in making system work harder to provide same level of cooling effect.

Flow Rate of Water: Performance of refrigeration equipments such as chillers gets affected by modifications brought upon in flow rate of water. In case flow rate of water is lower that standard level then it reduced efficiency as well as causes laminar flow.

On similar lines if flow rate is too high then it can cause erosion of tubes, noise and also vibration. Thus it is better to maintain in the range of minimum rate of 3 FPS and maximum of 12 FPS.

If you are looking to purchase quality chillers then Refcon Chillers is the right company to purchase the same from. They have a large of many different types of chillers for you to choose from depending upon particular requirement you may have.