Dmx fog machine

Introduction

Before turning on the machine, make sure there is enough fog liquid in the tank. This machine accepts most fog liquids and various densities for light or heavy fog. Air recommends to use Air fog liquid or JEM fluids as these give the best results. Proper fog liquid leaves less residue, is more efficient/economical and creates almost odorless fog. The liquid tank of your WSM device has a volume of approximately 2.3 liters. Fill the tank for approximately ¾ of its capacity. Overfilling the tank may cause the liquid to spill during transport, because of shocks, impact and tilting of the machine. Fluid consumption depends on the type of fluid, the amount of fog that you wish to create and the time span of use.

Positioning

The WSM02 MKII and WSM03 MKII fog machines are most suitable for use on the floor or any other stable platform. A mounting bracket is also included, in case you wish to mount this machine to a ceiling, wall bracket or truss installation.

Control

The WSM fog machines are controllable in several ways. You are able to use the included wired timer remote, the included wireless keychain remote or you can control the device with a DMX controller (not included). Wired timer remote Connect this controller with the 5-pin DIN connector on the rear of the fog machine low lying.

? Interval selection: Determines the time span when the machine is activated.

? Duration selection: Determines the duration if the timer activates the machine.

? Output intensity: Output 0-100% (variable)

? Timer functionality on/off

? Continuous fog: Continuous operation with the selected output intensity

? Manual fog: Fog projection at the selected output intensity, when pressed

? Yellow LED: Timer function on/off

? Red LED: Continuous fog function on/off

? Green LED: Fog machine ready-indicator.

dmx fog machine control

When you are already in the possession of a DMX-controller, it is possible to integrate the WSM fog machines in your light show. The output of the fog machine can be adjusted with one DMX channel, from 0 to 100%. For optimal use of the fog machine on DMX, some basic knowledge is needed. Contact your local dealer for more information. Connect the fog machine to your DMX-controller, using standard XLR male to XLR female cables. Select the correct DMX starting address by using the dipswitch panel just above the XLR-connectors. The dipswitch value is stated just above the panel. By adding several values you are able to make combinations to reach the desired DMX value between 1 and 256.

Replacing the internal fuse Always check your power supply for faults before changing the internal fuse. When you suspect that the fuse is broken, remove the fuse cover, located just below the power inlet.

WARNING:

Always disconnect the fixture from your wall outlet or any other power supply to prevent electric shocks. Always replace a broken fuse with a new fuse with the same type and rating. When the fuse is replaced, always close the fuse-cover. Reconnect the fixture to your power supply to see if the problem is solved. When this does not solve your problem.

For more information about smoke machine dmx contact us at https://yourproequipment.com/lighting/fog-haze-dry-ice-machines.html

Our aim is to provide best information to all of our visitors. We feel very happy to serve you so visit to my article..