Led moving head zoom

Introduction

To determine the power requirements for a particular fixture, see the label affixed

to the back plate of the fixture or referred to the fixtures specification chart. A

fixture listed current rating is its average current draw under normal conditions.

All fixtures must be directly powered off a switched circuit and cannot be run off a

rheostat(variable resist) or dimmer circuit, even if the rheostat or dimmer source

voltage matches the fixtures requirement. Check the fixture or device carefully to

make sure that if a voltage selection switch exits that it is set to the correct line

voltage you will use.

Warning!

Verify that the voltage select switch on your unit matches the line

voltage applied. Damage to your fixture may result if the line voltage applied

does not match the voltage indicated on the voltage selector switch. All

fixtures must be connected to circuits with a suitable Earth ground.

Safety instructions

Always make sure that you are connecting to the proper voltage, and that the line

voltage you are connecting to is not higher than that stated on the decal or rear

panel of the fixture.

This product is intended for indoor use only!

To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make

sure that there are no flammable materials close to the unit while operating.

The unit must be installed in a location with adequate ventilation, at least

20in(50cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.

Always disconnect from power source before servicing or replacing fuse and be

sure to replace with same fuse size and type.

Secure fixture to fastening device using a safety chain. Never carry the fixture

solely by its head. Use its carrying handles.

Maximum ambient temperature (Ta) is 104?(40?). Do not operate fixture at

temperatures higher than this.

In the event of a serious operating problem, stop using the unit immediately.

Never try to repair the unit by yourself. Repairs carried out by unskilled people

can lead to damage or malfunction. Please contact the nearest authorized

technical assistance center. Always use the same type spare parts.

Don’t connect the device to a dimmer device.

Make sure the power cord never crimped or damaged.

Never disconnect the power cord by pulling or gagging on the cord.

Avoid direct eye exposure to the light source while it is on.

Technical Specification of moving head lights

???Extremely small, fast and powerful LED Moving Beam,

???DMX Channels: 9/12/16CH

???Pan/ Tilt: 650*/ 240* speed adjustable

???Smooth electronic dimming: 0-100%

???Electronic strobe with pulse and random effects

???High efficiency, low power consumption

???Super compact, low weight

Weight: 5,7kg

Voltage: 100V-240V, 50/60Hz

Fuse: T6.3A

Power Consumption: 150W

Light source: 3W LED x36 (R8, G10, B10, W8)

Dimension: 375x322x445mm

Fixture Cleaning

The cleaning of internal and external optical lenses and/or mirrors must be carried

out periodically to optimize light output. Cleaning frequency depends on the

environment in which the fixture operates: damp, smoky or particularly dirty

surrounding can cause greater accumulation of dirt on the unit’s optics.

??Clean with soft cloth using normal glass cleaning fluid

??Always dry the parts carefully

??Clean the external optics at least every 20 days. Clean the internal optics at

least every 30/60 days.

For getting more information about led moving head zoom visit the website http://yourproequipment.com/lighting/moving-heads.html

Our aim is to provide best information to all of our visitors. We feel very happy to serve you so visit to my article..