- Views: 17
- Report Article
- Articles
- Business & Careers
- Industrial
5 Essential Tools For The Carpentry Of Each Advanced Carpenter
Posted: Oct 28, 2018
There is an old saying that says: It is a poor craftsman who blames his tools. I think that is only partially true. In fact, it is the responsibility of the craftsman to create the best possible pieces of finished work. But, to tell the truth, if you do not have the right tools, a high quality result may be out of reach. My complete list of essential tools probably has a couple of hundred elements. But if I check them all, you will not have time to spend in your store. Therefore, to control it, let's explore my list of 5 essential carpentry tools for each advanced carpenter clamp. We will see 2 small tools and 3 large children.
If we were all born with three arms and hands, carpentry would be much easier. We could use two hands to hold a couple of pieces of wood and the third to handle the screwdriver or hammer. But, for us, mere mortals with two hands, joining the pieces while we join them is a necessity.
In my own store, I have C clamps, bar clamps and spring clamps that vary in size from 2 inches to 6 feet. But there is a particular clamp that is a champion to go to.
The Rockler® 3-way face clamp is an easy to use but fantastic design. It is definitely a must for any advanced carpenter. Grasp the front frame of a cabinet edge, or a shelf edge, precisely. Yes, there are other 3-way C clamps on the market, but this feature-rich entry is a winner.
Let's start with the quick release threads. Do you see those yellow buttons on the clip? Push and release the threads, allowing you to secure your pieces in a second without having to turn the handles over and over again. And again and again. Non-damaging rubber pads mean you can use the 3-way Rockler on finished wood without fear of damage.
The main clamps open 5 inches and the jaw has a depth of 3 inches. For around $ 38, it's such a fantastic design that Rockler has a patent pending for it.
Hiding the screws that hold a fine piece of furniture is the signature of any advanced carpenter in carpentry. A traditional method is to use so-called pocket screws. A hole is drilled at an angle on the hidden face of a piece of wood that is going to join another. A specially designed screw is inserted into this "pocket" and runs through the edge, into the next piece. For a completely concealed closure, you can stick a wooden cap in your pocket and sand lightly with the surrounding surface.
Facilitate this complicated task with the Kreg Jig® R3 kit. It contains everything you need to make perfect pocket screw connections. Simply hold the template in place, drill the pocket, insert the screw and continue! Yes, it is that simple.
They have thought of everything in this kit. The sturdy nylon insole has two drill guides lined with metal, which means you can hold it very close to a corner, if necessary. The insole has a pair of independent slide adjusters to allow you to drill pockets in materials ranging from ½ "to 1 ½" thick with perfection. The marks on the sliders do the calculation for you, so you do not need to do calculations
You can buy the template separately, but I recommend this kit because it comes with everything you need. There is a specially designed bit with a locking ring, so you can drill each hole exactly at the same depth. There is an initial variety of pocket screws in lengths ranging from 1 ¼ "to 2 ½" along with a special drill for the driver, and even 5 wooden dowels, cut at the right angle so they are flush when inserted into the hole. All in a high resistance lock box. For around $ 45, it is a must-have for all advanced carpenters.
scaffolding pipes and fittings