How To Lay Floor Tiles like a professional 101

Laying floor tiles is not an easy task especially if the previous ones need to be rooted up before laying new tiles. Nevertheless, the process once understood properly can be carried out but it will still require you maximum effort and a lot of time.

In this 101 introduction of how to lay tiles, I will take you through the basics of all the steps involved starting with tools required and material required and then moving on to surface preparation and go all the way to laying tiles.

Tools Required

Keep in mind that for any commercial flooring tile company near Sandy UT the cost of tools are distributed over a number of jobs and therefore the cost of tools becomes very little per flooring project. If you are choosing to the tile you floor yourself the cost of buying new tools will be incurred at its full on your single DIY project.

Now let’s take a look the list of tools required.

• Pencil
• Tape
• Level

Trowel

• Rubber Float
• Speed Square
• Grout Sponge
• Power Drill
• Tile Spacer
• A big bucket
• Scoring Cutter
• Handsaw
• p>

The tools required might differ by a count of 1 or 2 depending on the type of tiles that are being installed.Material Required

The material that is required will stay the same in nearly every kind of tile installation.

• Sealer
• Cement Backer Board
• Cement Board Screws
• Tile
• Thin-Set Mortar
• Grout

Surface Preparation

Surface preparation is a major part of tiling your floor. Start by removing any existing tiles that are installed on the floors. It is essential that you remove any residue, mortar, adhesive or any other kind of material that was used to bind the tiles to the floor.

If the floor turns out to be not leveled, you would have to level it first.

If you are working with wood framing make sure to check if the subfloor is rigid enough, dry and is attached to the joists securely.

One thing that you must never do is apply tiles directly no a wood subfloor or a plywood surface. Tile should be applied only after covering such surfaces with cement backer board. Use a rust-resistant screw to fix the backer board.

Create A Layout

Maximize the aesthetic appeal by first making a plan to layout tiles in a manner they don't need to be cut a lot in order to fit. You can either center the tile or start laying out tile from the wall that is the most prominent.

Laying Tile

Time for laying tile. Just in case, if you get stuck in the middle of tiling and don’t know what to do or you there is something that has gone wrong with the preparation, you can always give a call to any tile repair Sandy UT service and they will rush to your aid.

You have to mix mortar in a 5-gallon bucket with the help of a mixing paddle. Use a low-speed drill with the paddle if you have to. Use the correct ration of water and mortar to mix with each other.

Mortar dries up fast so only make enough with which you can go for 15 to 20 minutes.

To wipe an excess keep a bucket of clean water and sponge near at all times. Use this sponge to clean your tools once you are finished.

The use of a notched trowel is a great idea to spread the mortar on a small area evenly.

As keep on fixing the tiles make sure to check regularly if the tiles are being placed straight and are leveled with each other and the floor.

I am Abbie Samuel, an expert professional content writer, and Seo specialist. I love to help peoples in their marketing strategies and provide them with the best advice.