8 Simple Tips for Refacing the Kitchen Cabinets

Kitchens require attention to every little detail, whenever you are cooking something or revamping the overall outlook. Therefore, refacing the kitchen cabinets would obviously mean that you need to learn the right skills and take care of the delicate materials involved in the process.

To have a thorough understanding of cabinet refacing, before you decide to do it for your house in Bloomington MN, one should broadly know that it is all about covering the old cabinets with the new surface. The materials that are often used to replace the skin includes veneer, a thin surface of wood, thermo foil, and plastic laminate.

It is a lot more budget and environment-friendly when compared with replacing the kitchen cabinet entirely. However, you can save up even more, especially the cost of hiring a cabinet refacing contractor if you just learn how to do it on your own. While you may think that doing it can be tricky, but the truth is that you will become a master at refacing only if you try by following the eight easy steps listed below:

1. Take off the Cabinet Doors and Prepare Them.

Start things off with removing all the cabinet doors. This is done in order to clean the faces and remove grease stuck on the sides of the cabinets. Once it dries up, scrape the surfaces with sandpaper.

Put carpenter’s glue onto the plywood panel and stick the exposed end of the cabinet to it. To further tighten up the panel, hook nails.

2. Cover All The Rails and Stiles With Veneer

Measure the vertically framed stiles and horizontal rails, followed by cutting the veneer into strips that should remain half an inch wider than your measurements and 2 inches longer than each stile and rail.

After that, align it in accordance with stile as in it should overlap with the edges and put the veneer above it.

3. Press The Veneer Down

Keep on pressing the veneer along the length of the strip with a wood block. By doing so, you will be able to get rid of all the bubbles.

4. Time To Reface The Cabinet

As soon as you place the veneer on the stile, trim the edges with a knife to make sure that the excess overlapping shouldn’t interfere with the opening of the cabinet.

5. Attach Cabinet Rails With Veneer

Apply veneer to cover the cabinet rails in such a way that it should overlap on both sides.

6. Cut the extensive Trimmings

All you have to do now is simple peel off the extra rail veneer from the ends and lift the edges with a razor. It will expose the cut piece of the style beneath.

Next, push the rail veneer back again and try to soften all the face frames.

7. Install Doors

Hang the door by screwing hinges, line up the door in the cabinet opening and screw it to the frame. To position, it correctly, close the door and further tighten the screws.

8. Put on The Cabinet Hardware

Finally, make holes for cabinet hardware such as knobs or pulls on the front of drawers. Attach them up with screws and you will be good to go.

Even if your kitchen cabinets are in good shape, refacing can still be a viable option to give them a brand new look. It can add more value and improve the environment of your kitchen as well.

Iam a talented writer and experienced blogger and I have contributed my thoughts and articles to many renowned websites and Blogs.