Projector Care Tips | Projectorcare.com

Take Good Care of Your projector to extend your projector’s life:

Become familiar with the unit before your first presentation or event.

To prolong lamp life, always allow your projector to cool completely before turning off or unplugging.

Remember that excessive heat can greatly shorten your lamp life.

Do not operate your projector in direct sunlight or near a heat source.

Change filter, if applicable, as specified in your user manual.

Never operate the unit without the air filter, if applicable. Doing so can draw dust into the optics of the projector, which can be projected on to your image.

Avoid using your projector in a smoky environment. This can cause damage to the optics of the unit and can void your warranty.

Store your projector in a cool, dry area. Save the shipping box for safe secure storage when not in use. If the need arises for you to ship your projector in the future, the original box and packing material is the safest way to pack your unit.

If a projector is mounted to the ceiling, be sure that the area near the intake fan is kept clean and not in direct line of air or heat vents because sometime the dust get collected on the lens of the projector which make it unworkable.
If possible check your projector to the technician so if there is any problem started in the projector the technician can resolve and the dust collected in the projector can be removed because sometime what happen that all the dust get collected on the fan which make it unworkable.So it is very important that the fan work fine.
Once you're through with using your projector, don't just shut it down immediately. Allow the fan to run a little longer. This is because projectors tend to get extremely hot, and stopping the fan before enough cooling has taken place would ruin the various components. Allow the fan more time and protect the projector from heat damage.
Touching the lamp of your 1080p led projector may leave an oily sweat mark on it. When the lamp heats up, the mark hardens into a blackish spot that causes some light to be blocked and the effect to be amplified on the screen. It may cause your 1080P picture quality to degrade. If the spot is large, it could even cause the lamp to break. So, never touch the lamp, whether cold or hot. Besides, a hot lamp would burn your hand severely.

The Econo mode reduces the heat generated by your video projector. As a result, the components don't get damaged by excessive heat. It results in a longer life for your projector. Only use the projector's full brightness when necessary, such as when projecting in outdoor conditions.

In any case, a Home Theater 1080P Projectorwill have fewer viewing problems in the various modes. Your LCD projector may require you to use brightness more than an LED projector; be sure to read the user manual guidelines, so you don't decrease picture sharpness.

If you are looking for a projector repair services in Amritsar, Jalandhar, Ludhiana and Chandigarh

Visit our site for more info:http://projectorcare.com/

I am architect who develop, planning and do construction work