How to install a wall-mounted tap in a bathroom - diy

Have you opted for a wall mounted or even concealed tap for a number of reasons, such as to save space or perhaps because the water supply from your bathroom required it? As its name suggests, it could be placed directly against the wall, above the bath, the basin possibly in the shower.

Before beginning the work, you must ensure the structure has an outlet for embedding the water resource pipes and the sealing pipes or perhaps fittings utilized to bring a pipe from a wall. If you do not, call an expert, as it will take a bit more work.

Great to know: before selecting the wall tap, remember to determine the distance between the two sealing pipes (one for water that is hot, one other for cold water). It's rarely precisely the same as the center distance of the mixer. This step is thus required to find suitable tools, even if the eccentric connections let you enjoy a bit on the gap.

1. PREPARE THE WORK SURFACE

Turn off the water supply to the house. Open a tap to work off the remaining water and take out the previous residues contained in the pipes. Shut it.

Tip: Remember to plug the drain to avoid areas of the faucet from falling into the pipes.

Wall tap

2. ENSURE THE TIGHTNESS AND FIX THE ECCENTRIC FITTINGS

A wall-mounted tap attaches straight to the sealing pipes situated at the end of the pipes. These are apparent on the surface of the wall.

Using a measuring tape, check that the distance between the two sealing pipes is comparable to that of the mixer heads. In addition, measure their diameter to determine the size of the offset eccentric fittings you will use. These are placed directly on the sealing pipe to set the amount of the valve.

Seal the fittings by addressing the threads with Teflon. Joint paste is a good option.

As soon as sealed, attach them with regard to the sealing pipes.

Start by screwing the two elements by hand, then simply finish by carefully tightening them using an open end wrench.

3. INSTALL THE WALL VALVE

Decorative rosettes are often provided in the buying kit. If this's the case, slide them around the eccentric fittings and screw them by hand.

Position a vulcanized fiber gasket in each and every nut on the wall valve. The seal is important to assure the seal between the head and the body of the gear.

After that place the tap on the fittings, screw it by finish and hand by tightening with the open-end wrench.

Examine the horizontality of the equipment and have a spirit level. Adjust the tightening of the eccentric fittings if necessary then tighten the nuts with a wrench.

Wall fittings

4. CHECK THE INSTALLATION

These days that the valve is installed, all you have to accomplish is check out the related equipment for leaks.

Restart the water source to the building.

Open the tap and let the water run for a couple seconds. No leaks on the horizon? You have successfully carried out the work. Alternatively, if the mixer leaks, unscrew the nuts and check which the two fiber seals are the right way placed. If the leak continues, contact an expert.

Remember: If you installed your new wall mounted faucet in the shower of yours or above the bathtub, you still have to correct the shower hose along with the hand shower.

Should you have not chosen your wall mounted tap, you are able to have a look on the site of ours on the selection of ours. Also discover the products of ours in store, in Paris or in Lyon.

Tips By: https://myhomeneedz.com/