Configuration of Netgear Nighthawk Wifi Range Extender AC1900

The AC1900, dual core 800MHz gives you lightning speed wifi connectivity throughout your whole house or office and the performances is boosted up like never before. Your current router becomes the gateway for a whole home mesh wifi with this nighthawk extender and HD video streaming experience will be like never before. Configure it with mywifiext.net and enjoy maximum internet coverage and range to all the dead zones.

Features

The features of the AC1900 Ex7000 has lots to offer you which will become one of the most useful assets for you because of the growing use of technology today. Here is the list of its features –

• It comes with high powered amplifiers of 700mW
• Speed of up to 1900mbps giving maximum connectivity
• Works with any kind of wifi router and syncs well
• Signal coverage of at least 3 external antennas
• Both the wifi bands are used with the FastLane technology thereby increasing the signals
• USB 3.0 is provided for a faster access of your stored data
• You can connect many wifi enabled smart devices like smart TV, gaming consoles etc. to the extender’s 5 x Gigabit ports
• You can make any printer Air print compatible now and print with your iPad or iPhone devices
• A CD-less setup and one push and connect WPS method setup

Setup of AC1900

The setup of the Netgear wifi range extender using the Installation assistance is quite simple, however you can also go for the WPS (Wifi Protected Setup) method which just needs you to push one WPS button on the extender and router. Here are the steps for the web based setup –

1. Place your extender in the same room where the router is
2. Check your web browser if it is up to date
3. Your internet connection should be in working condition so check the status
4. Now plug your range extender to a wall outlet
5. Connect it with the laptop or desktop computer and see that the power LED is lit solid green
6. Now open a web browser and go to the address bar

7. Type the site address http://mywifiext.net and press enter

1. You will be shown the login page of the Netgear extender
2. Enter the default credentials that is username - admin and password – password
3. Press login and continue
4. You will be redirected to the setup page
5. Follow the instructions and prompts on the page to configure your extender’s settings
6. Save all the settings before going forward
7. Register your device and finish the mywifiext setup process

This is the web based setup of the wifi range extender using the installation assistant, you can see the steps for the WPS method below –

1. Power on the extender and see the solid green LED light up
2. Press and hold the WPS button on the extender for few seconds
3. Release the button and immediately press the WPS button on your router. It should be pressed within 2 minutes of press it on the extender
4. The extender and router will establish a connection and sync
5. When the extender is successfully configured then the LED on the extender will stop blinking which means it is setup now
6. Move the extender to the best location where it gets maximum wifi signals

Connect the wifi enabled devices to your extender and enjoy the benefits

Tech Enthusiast | Lifestyle | Fashion | Digital Marketing | Social Media