The reasons you should consider garden irrigation

The main reason to utilize any type of irrigation type is to ensure a consistent supply of the most vital necessity for the growth of plants and that is water.

The stress caused by droughts even for short span of time like a week or just few days can strikingly impact the quality of your garden. A dependable, effective irrigation system protects the considerable amount of money and time you have invested in your garden projects and landscape. This is the reason an irrigation system for your garden is very important.

There are mainly two basic considerations in choosing the best type of garden irrigation system to utilize for any garden, like consistent water delivery and control over the quality of water delivered. As a matter of fact, it is frequently just as damaging and stressful for you plants to serve more water as it is to serve less water. In our experience, drip irrigation systems are much more efficient and inexpensive in addressing these problems than by other techniques.

Different types of irrigation systems available

1. Micro-porous tubing: Utilizing relatively low pressure like that of a garden hose when pressurized, it will fill completely until a critical pressure threshold is reached. At that point water starts to be uniformly emitted from all the pores at a time. The material utilized in the tube is a spun bonded plastic that is extremely robust, resistant to bacterial growth, and impossible to clog. If this is not sufficient, the expectancy of the product life is almost 10 years, which is quite rare for irrigation systems. We love the efficiency of this technology, and recommend this type of irrigation system to everyone.
2. Porous rubber hose: Being made from scrap rubber tyres, this product gives out water through small perforations in the hose wall. It suffers from non-uniformity of water deployment, short span of life due to clogging and rotting, and is quite expensive than other products.
3. Drip Tape: This is collapsible black plastic film tubing and comes with emitter holes 8 to 12 inches apart. Flow and pressure rates are lessened through seal chambers and irrigation controller which have a tendency to plug, even when utilizing chlorinated and filtered water. The initial cost of the tubing is quite low, but usually comes with clogging problems.
4. Emitter: These systems deliver water through non-porous plastic tubing to evenly spaced drippers or emitters. These emitters are quite simple to install but need frequent maintenance to modify the flow and to unplug. The initial cost involved in this type of irrigation may be substantial, as it is an ongoing operational cost of rendering chlorinated and filtered water.

The best way of capturing and storing water is by utilizing raised beds. If you want to utilize the above mentioned options to provide irrigation, be sure that the water is not polluted, as it may damage your plants.

About the Author :-

JG Irrigation is your one-stop solution for irrigation, irrigation controller , garden irrigation. Visit us now for more information about our products.

Refer to: http://www.jgirrigation.online/ to know more about Irrigation Solenoid, Irrigation Supplies, Pop Up Sprinklers