Signs That Tell the Security Cameras Are On the Verge Of Getting Damaged

Undoubtedly the chief function of the CCTV is to ensure that you are safe along with your family members. Your property, family and belongings are subject to risks of intrusion, theft, kidnapping and crime; but only if you are wise enough to install CCTV cameras and various other security tools, will you be able to enjoy that sigh of relief. However, being an electronic device, the CCTV camera is subject to wear and random damage. Some signs which evidently tell that the system might be at a risk of failure or is actually damaged have been mentioned below. Note that our aim is to point out these primary aspects so that you can seek timely action. Watch out for these signs now:

Electrified Surface

When getting a good security camera installed at your premise make sure the device is able to cover maximum area and that the image should be of high standard as well. However, a very important thing which you must note before getting the camera installed, is you must avoid bolting it with any metal surface which is otherwise termed as an electrified surface. It’s a fact, an electrified surface causes bleeding of the image due to electric current. The situation is not uncommon. It can further happen because of faulty electrical wiring causing the current to pass through the conductive surface and reaching the device until the camera gets electrified. That’s why you are recommended for opting out metal surfaces when mounting the camera.

Sunburn

Some manufacturers do not state whether the product is suitable for an outdoor installation. If you do not find it written specifically on the product’s users’ manual or specifications, you better keep it for indoor use. This means the camera is not suitable for outdoor installation. One of the possible reasons is the ability of direct sunlight to cause damage to the camera. As sunlight travels and reaches the lens it directly hits the image sensor and causes distortions to the glass. The result is worse. That’s why when installing security cameras in Perth you ought to be careful about where you are placing the device. Furthermore you may also notice blurry images. If you witness blurriness or change in colour of the image it could be because of sunburn.

Infrared Cut Filter

The infrared cut filter is a vital specification for security cameras. If the camera you have purchased lately for home security doesn’t have a cut filter, then it’s probably not meant for outdoor installation. You will witness the problem when after repeated attempts to dim the brightness of the camera you continue receiving images which are too bright. Although the scenario may pop up outdoors, likelihood of the same thing happening indoors can’t be overruled. This occurs when some indoor light is too bright.

Power Supply

There are several factors that can significantly affect the power supply to the CCTV cameras in Perth. As a result, rolling lines will start appearing on the images. Watch out for such rolling horizontal lines which signify a problem with the supply. Problems such as these should be handled by trained electricians only.

Since these are surveillance cameras they are subject to constant use, which make them vulnerable to wear and damage. That’s why if you ever notice such types of problems, get them solved at once.

The author is a blogger who loves to write on different topics and provide valuable information to his readers.