The Different Types of Pressure Cleaning

Pressure cleaning or pressure washing is basically the application of high-force water via a hose to remove dirt, loose paint, grit, dust, dirt, chewing gum, and mold from surfaces and other objects like concrete surfaces, vehicles, and buildings. Although these kinds of cleaning agents are generally used for cleaning cars and for maintaining its shine, they are also used for removing oil stains, grease marks, and dirt from flooring and interiors of commercial establishments. The reason why these cleaning agents are used widely is that they are very effective at removing tough dirt and marks. They can also remove poisonous molds and fungi from your home and protect you against allergies and respiratory issues. Hence, they are now being used as residential cleaning agents in homes and offices.

There are various ways in which you can use pressure cleaning tools. There are three kinds of methods: hot water pressure washers, cold water pressure washers and electric dryers. Some homeowners prefer to use hot water pressure washers because they produce enough heat to melt even hardened grease and dirt. However, if you have pets at home, it is best to use cold water pressure washers as they will not affect your pets. Some homeowners also prefer using electric dryers because they produce less heat and are easier to use.

The first step in pressure cleaning is to prepare the tools and the cleaning solutions. You need a bucket with at least two to three gallons of water and at least three to four gallons of chemicals for the different areas that you are going to clean. These chemicals are specifically formulated to remove stubborn grime and grease that will not dissolve into the bucket's high-pressure jets. When cleaning floors, a pressure washer is not enough; you need a vacuum cleaner with a wet/dry function.

After preparing the equipment, you can start pressure cleaning. Start cleaning with a tarp or other protective surface and use high-pressure water washers to clean stubborn surfaces such as flooring and showers. Use your vacuum cleaner's wet/dry function on hard-to-reach or extremely dirty surfaces such as tubs and toilets.

After getting rid of the dirt, you can now rinse off the surfaces to prevent them from being re-soiled. After rinsing, you can now proceed with the polishing. The grime should now be completely removed. If not, repeat with the second or third application of the pressure cleaning solution and the high pressure air washer. When you are done with the first application, spray some cleaner onto the grime and let it sit for five to ten minutes. Then wipe it off using a clean sponge.

With stubborn grime and greasy grease, there is no other way but to use high pressure hot water pressure washers to clean them thoroughly. You will then use a scrubbing pad or soft sponge to get rid of the detergent residue left behind by the detergent. Be careful not to let any residue stand on the faucets as it may cause some damage. Rinse it off properly. Again, spraying hot water onto the grime should help to loosen the dirt. Make sure you are wiping it down carefully and avoiding putting too much detergent on the area as this could damage the faucets.

For outdoor furniture that requires frequent cleaning, the high pressure washers' cycle would work better than the suction-only ones. This is because the detergent-saturated sponge can only remove the soot and mildew that have accumulated on the fabric. Using the cycle of the pressure washers, the detergent is left behind to dry, fluff up and get rid of the dirt.

When pressure cleaning concrete, it is best to use the right equipment and chemicals. There are a number of chemicals used in this type of cleaning process that are toxic and/or corrosive. Using these products can put both people and property at risk. The correct equipment will protect both the user and the surrounding area from harm. For example, the wrong chemical can burn the skin of an unprotected user, if inhaled, or can damage the concrete surface. If using power washers with pressurized water, it is very important to wear the appropriate personal protective equipment such as hard hats, safety glasses and gloves.

Brett and Leona established B&L Exclusive Cleaning Services in 2001. At the time Brett was working for a telecommunication company but he had prior work experience in the cleaning industry.