Electrical Safety Tips for The Organization

Today, any organization setting operates on electricity. Electrical equipment, from computers to machinery can all be possibly dangerous and can cause shock and burn damages if inappropriately used or maintained. Though most general personnel don’t want specialized Electrical safety training, if work around electricity, but are not qualified to straight handle electrical components, it’s significant to follow electrical safety-related work practices to keep yourself and others safe. Here are electrical safety tips for the workplace, which helps to avoid electrical hazards:

Avoid All Potential Contact with Live Electrical Current: Unqualified personnel should not interact or come close to electrical currents more than 50V. If must work in the same area or room as an electrical danger or equipment operating on more than 50V, keep a safe distance. All panel doors should be shut, and there should be no exposed wires around work area before begin operations.

De-Energize Equipment and Use Lockout: Exposed, live electrical parts must be de-energized before work on or near them is allowed. Prevent accidents and isolate electrical energy by locking the electrical system or parts of the system according to organization’s Lockout policy.

Confirm Safe Use of Electrical Equipment: Correctly using all electrical equipment can go a long way to confirm everyone’s safety in the workplace. Employees should take care to handle electrical cables properly:

• Always unplug cords by pulling on the plug head, rather than the cord.
• Don’t press or overstretch electrical cords.
• Don’t fasten cords with staples.
• Don’t hang electrical equipment from cords.

Also, all cords and plugs in the workplace should be visually examined for external defects prior to use. If encounter a plug with damage, do not use that equipment.

Install Proper Physical Barriers Around Electrical Dangers: Physical barriers should always be used to defend employees from any electrical hazards. Cabinet doors on electrical panels should always be closed, and panels should not have holes where an employee could come into contact with exposed wires. If cabinets cannot be closed, or if an electrical hazard cannot be fully closed in, barriers, or insulating materials should be used.

Be Careful of Conductive Tools and Cleaning Materials: If working in an area where an electrical risk is present, always take up those electrical parts are live, and act accordingly. Do not use conductive tools in the area. If cleaning the area, note that some cleaning materials are conductive as well and need additional caution. Solvent and water-based cleaning materials are electrically conductive, as are steel wool and metalized cloth. Keep these cleaning products, as well as any conductive tools, away from live electrical parts and equipment.

When Working Above, Look Overhead for Electrical Lines: When performing any work overhead, be careful of electrical lines. In most workplaces, there is the potential for live electrical equipment and parts above the floor level, which are only accessible with ladders. Assure that use a portable ladder with non-conductive side rails, and stay at least 10 feet away from any exposed electrical lines while performing overhead work.

Use Extreme Caution with Flammable Materials: Electrical equipment that can cause explosion must not be used where flammable vapours; gases are present. The only allowance to this rule is when qualified personnel take measures to lockout and isolate electrical energy sources before these potentially flammable materials may be used.

Only Qualified Personnel Should Work on Live Electrical Wires: Only qualified personnel with the appropriate training should work on live electrical wires. The same electrical safety protection applies to hazardous electrical equipment. Any live electrical danger should only be approached and managed by qualified personnel. If see a live electrical wire that is not attended, notify the appropriate electrical safety personnel, who should instantly place physical safety barriers.

Always Follow Organization’s Electrical Safety Work Practices: Every organization has unique electrical safety work practices depending on the electrical equipment and dangers present in organization. It is significant to always follow organization’s precise electrical safety work practices to keep employees safe.

Electrical Shock Can Be Deadly: Electrically live parts do not look different from de-energized parts. To confirm safety, it’s best to assume that any electrical part is live. Take protections to keep power on its path, and protect yourself.

As ISO Consultant profession since last many years Charles has rich experience in preparing such certification documents within ISO guideline to his global clients to acquire better ISO Certification Solution to their Organization.