How to Setup a Mason Bee House

Setting up your bee house is a simple project that takes just a little bit of planning and a few minutes every year. Follow these easy steps and enjoy your pollinated fruits, vegetables and flowers.

TIMING:

It is ideal to release your bees so they will be active when the blossoms on your plants are blooming and ready to be pollinated. Put your house out when the blossoms are starting to swell and the chance of frost is low. For Blue Orchard Mason Bees and other springtime bees this is when the temperature exceeds 50*consistently. Bees will emerge 1-14 days after warming up. The Garden Bee ( aka. Alfalfa Leafcutter Bees ) and other summertime bees won’t emerge until temperatures consistently reach 70*. Placing the springtime bees and summer time bees in the same house in the spring works well.

RELEASING BEES (IN TUBES):

Putting the tubes of bees in backwards is the most common mistake made when setting up the bee house. It is important to look at the tubes and place the opening of the tubes facing out so the bees can emerge. The filled tubes will have a node in the back (shown in top image) and a plug the bee formed in the front (shown in bottom image). The plug will look like mud or leaves. It may be necessary to shine a light into the tube to see the plug as the bees fill tubes from back to front and may not completely fill each tube.

Once the tubes of bees are in place, tightly pack more tubes in the house. Making sure the tubes are snug will help prevent predators from getting to the bees.

LOCATION:

Face the bee house between south and east for optimal pollination. Bees are cold blooded and use the heat from the morning sun to get flying in the morning. Find a secure place like the side of a shed, fence post, or tree. Make sure the bee house is at least three feet from the ground to deter ants. If you have squirrels in the area you may want to squirrel proof the house with chicken wire.

It is best to have the house angled slightly downward so that any water that may get in the house will run out (using a nail or screw with the provided bracket on the house is sufficient).

CLAY SET UP:

Setting up the clay source is the last step to ensure your Blue Orchard Mason Bees are the most efficient and effective pollinators. The Blue orchard bee requires a clay source to create the cells between larva and to plug the end of the tubes. NO CLAY=NO MASON BEES. For the other types of bees it isn’t necessary to have a clay source though they might use it too.

Bees are weak fliers when they first emerge so it is best to place the clay near the house but not directly under it (making the bees less likely to fall in).

You can dig a small hole to dump the clay in or just leave the container of clay out for the bees. It is best for the clay to stay moist so it is easily accessible. Just make sure to add a little water to the clay if it starts drying out.

Once you have all the set up complete it's as simple as watching your bees work and occasionally watering the clay.