Gamma Foundries

Quality management is one of the most important factors to consider when it comes to manufacturing using sand casting. This is to ensure the quality and standard of the end-product you will get after...

Metal casting is the process in which products are replicated by pouring molten metal such as aluminum, magnesium, copper alloys, etc. into a cavity and allowing it to solidify. This process is most...

The history of sand casting dates back more than 1000BC and this makes it the oldest of the known casting processes. Over the years since then, a lot of evolution and development has taken place...

When it’s time to ramp up production, manufacturers who rely on specialized metal parts, fittings and hardware are likely to find these items simply cannot be cost-effectively produced in house. A...

Sand molded casting, popularly known as sand casting, is a metal casting process in which sand is used as the mold material. A factory where sand casting is carried out is known as a sand casting...

Creating all components for a product in-house can be a smart way to ensure quality and access to items critical in the supply chain. There are some components, however, that are best left to experts...

Lead has been widely used in the metal casting process for a long period of time. Until the negative effects were discovered, it was frequently used by sand casting companies. However, with the new...

Designs can look entirely different on the paper as compared to how they look in 3D, in reality. When companies come up with designs for products, it can be helpful for them to see the product in a 3D...

Did you know that many people believe that brass is probably one of the oldest materials still in use today and that it may have been around since pre-historic times? That question may not yet have...

There are plenty of sand casting companies in the marketplace. These companies specialize in producing high quality ornaments that are used for various purposes. They use 3D printing sand casting...

Taking a new product design from the conceptual phase to full market release demands lining up the right suppliers to make any necessary components that cannot be created in house. When metal...

When it comes to sand molding, Green Sand is definitely the most diversified of the molding methods that bare in use today. The term green however does not quite denote what most people might expect...

Bringing a new part or product idea off the drawing board and into production demands a meticulously run testing process. Foundries that offer rapid prototype castings can help get the job done right...