Be Thorough With Your Theory And Practical Sessions To Get A Good Desktop Engineering Job

Get ready to face some below mentioned questions if you want to grab the best of desktop engineer openings in Delhi NCR. You might be questioned about the use of Safe Mode and when should we use it in Windows. Now, if you have a good knowledge of related field, you should know that we have to start Windows in Safe Mode in order to remove spyware or for troubleshooting driver problems and other diagnostic purposes. Only specific programs and files with limited driver support are needed to run the operating system. This will allow you to attempt to remove viruses, change bad drivers and perform other diagnostic tasks that cannot be done in Normal Mode. The interviewer may further ask you how you start in Safe Mode. Here, you may answer systematically saying that if you follow method one, then reboot the computer. Start pressing the F8 key as soon as your system starts to boot. This will open multiple boot options including Safe Mode. And if you follow method two, open Run, type "msconfig" and press Enter. A system configuration window will pop up; now go to the Boot tab, check the "Safe boot" box and select "Minimal" for a typical safe boot. Click Apply and your computer will boot into Safe Mode the next time it restarts. Some other questions for which you should be prepared are the use of BOOT.ini file. And you should know that Boot.ini files are required in booting Windows operating systems, starting with Windows NT. The boot.ini file also provides flexibility for dual booting multiple operating systems on the same computer. For editing Boot.ini, open Run, type "msconfig" and press Enter to open System Configuration Utility. Select the tab labelled BOOT.INI. Click the button labelled Check All Boot Paths. A dialog box will open detailing the location of any invalid operating system locations.

As you enrol yourself in a good computer learning institute for desktop engineering course, you would be taught the commands to use to check IP configuration. You would learn to use ipconfig /all to display all of the current TCP/IP configuration values, including the IP address, subnet mask, default gateway, and Windows Internet Naming Service (WINS) and DNS configurations. You will also learn how to make your hard disk dynamic by going to Run and typing diskmgmt.msc. After that, right click on hard disk to convert a basic disk to dynamic disk. All this knowledge will be quite useful for you to get a good desktop engineering job.

The number of jobs in the field of desktop engineering is growing in an unprecedented way. And not to forget that these openings are at all levels, including fresher and middle and higher level.