HP 49 Service Error

HP Printer 49 Service Error

The HP 49 Service Error takes place due to an internal communication issue. Here, the firm lead to a serious error and the formatted processor aborts its operation. According to HP Support experts, HP printer service error 49 is a serious cause of a bad printing command, various invalid operations, firmware and corrupted data.

While using a technical device, you don’t need to forget that you can face any kind of errors. But, the major problem is to fix Service Error 49 without damaging the HP printer. Here, we will talk about the causes and ways to get rid of this nasty error with some easy as well as quick steps.

Look at the probable reasons by which this 49 service error can crop up in HP LaserJet Printer:

• Issues related to your hardware also causes this error to take place
• Due to the fault in network cable also causes this issue
• Outdated version of firmware
• Hard drive failure
• This server error might be take place due to an issue with DIMM.

These are some basic causes which are responsible for Service error 49 in your HP printers. In order to resolve this error, you need to follow the below mentioned steps.

Here are the ways to Troubleshoot HP Printer Service Error 49:

Check for connection

Turn off the device and then carefully disconnect all the communication cables or Wi-Fi connection. Wait for few seconds to again turn it back on and then connect all the cables properly.

Managing the Printer

Unplug the printer from the power cable and then remove all the accessories like EIO cards, memory, a duplexer, extra trays and envelope feeder. After that, plug each accessory one by one and see if the error still exists after each try.

Cold Reset method

Try cold reset or NVRAM initialization method. A cold reset process will reset every minor stored memory settings like internal and external jet direct settings or control panel settings. NVRAM is more intangible and clears out all the internal memory such as error logs.

Perform A Non-Volatile RAM Initialization

Switch off the power of HP printer and then remain idle for at least 30 seconds. Switch it on again and wait until it gets initialize. If still error continues, then perform a NVRAM initialization.

Resolve the Firmware Error

Firstly turn off your HP Printer and switch it on again. After that, disconnect the parallel cable and replace the DIMM of the Firmware. If this doesn’t work, then you can try replacing the Jet direct Card. If still the error continues to grow up, then you will have to renew the engine board.

Update the Printer Driver

Sometimes, outdated or faulty driver can cause the issue. So, you need to install the updated version of your printer driver within your computer.

By applying these measures, you can easily resolve HP Printer 49 Service Error and make your printer working again. However, if the error continues to grow up, then you need to take HP Support. This support services is well-admired among the people of Canada for providing optimum resolution to fix their issues. You can also grab the guidance from their professionals to fix this service error once and for all.

Source URL: https://medium.com/@ronansmith2103/hp-49-service-error-b1e96a1683dd

I'am Ronan Smith Working on HP Error