300-101 PDF Download

Question: 1

Based on this FIB table, which statement is correct?

A. There is no default gateway.

B. The IP address of the router on FastEthernet is 209.168.201.1.

C. The gateway of last resort is 192.168.201.1.

D. The router will listen for all multicast traffic.

Answer: C

Question: 2

A network administrator checks this adjacency table on a router. What is a possible cause for the incomplete marking?

A. incomplete ARP information

B. incorrect ACL

C. dynamic routing protocol failure

D. serial link congestion

Answer: A

Question: 3

A network engineer notices that transmission rates of senders of TCP traffic sharply increase and decrease simultaneously during periods of congestion. Which condition causes this?

A. global synchronization

B. tail drop

C. random early detection

D. queue management algorithm

Answer: A

Question: 4

Which three problems result from application mixing of UDP and TCP streams within a network with no QoS? (Choose three.)

A. starvation

B. jitter

C. latency

D. windowing

E. lower throughput

Answer: A, C, E

Question: 5

Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?

A. dual-stack method

B. 6to4 tunneling

C. GRE tunneling

D. NAT-PT

Answer: A

Question: 6

Which statement about the use of tunneling to migrate to IPv6 is true?

A. Tunneling is less secure than dual stack or translation.

B. Tunneling is more difficult to configure than dual stack or translation.

C. Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts.

D. Tunneling destinations are manually determined by the IPv4 address in the low-order 32 bits of IPv4-compatible IPv6 addresses.

Answer: C

Question: 7

A network administrator executes the command clear ip route. Which two tables does this command clear and rebuild? (Choose two.)

A. IP routing

B. FIB

C. ARP cache

D. MAC address table

E. Cisco Express Forwarding table

F. topology table

Answer: A, B

Question: 8

Which switching method is used when entries are present in the output of the command show ip cache?

A. fast switching

B. process switching

C. Cisco Express Forwarding switching

D. cut-through packet switching

Answer: A

Question: 9

Which two actions must you perform to enable and use window scaling on a router? (Choose two.)

A. Execute the command ip tcp window-size 65536.

B. Set window scaling to be used on the remote host.

C. Execute the command ip tcp queuemax.

D. Set TCP options to "enabled" on the remote host.

E. Execute the command ip tcp adjust-mss.

Answer: A, B

Question: 10

Which three TCP enhancements can be used with TCP selective acknowledgments? (Choose three.)

A. header compression

B. explicit congestion notification

C. keepalive

D. time stamps

E. TCP path discovery

F. MTU window

Answer: B, C, D

Question: 11

A network administrator uses IP SLA to measure UDP performance and notices that packets on one router have a higher one-way delay compared to the opposite direction. Which UDP characteristic does this scenario describe?

A. latency

B. starvation

C. connectionless communication

D. nonsequencing unordered packets

E. jitter

Answer: A

Question: 12

Under which condition does UDP dominance occur?

A. when TCP traffic is in the same class as UDP

B. when UDP flows are assigned a lower priority queue

C. when WRED is enabled

D. when ACLs are in place to block TCP traffic

Answer: A

Question: 13

Prior to enabling PPPoE in a virtual private dialup network group, which task must be completed?

A. Disable CDP on the interface.

B. Execute the vpdn enable command.

C. Execute the no switchport command.

D. Enable QoS FIFO for PPPoE support.

Answer: B

Question: 14

A network engineer has been asked to ensure that the PPPoE connection is established and authenticated using an encrypted password. Which technology, in combination with PPPoE, can be used for authentication in this manner?

A. PAP

B. dot1x

C. IPsec

D. CHAP

E. ESP

Answer: D

Question: 15

A corporate policy requires PPPoE to be enabled and to maintain a connection with the ISP, even if no interesting traffic exists. Which feature can be used to accomplish this task?

A. TCP Adjust

B. Dialer Persistent

C. PPPoE Groups

D. half-bridging

E. Peer Neighbor Route

Answer: B

Question: 16

Which PPP authentication method sends authentication information in clear text?

A. MS CHAP

B. CDPCP

C. CHAP

D. PAP

Answer: D

Question: 17

Which protocol uses dynamic address mapping to request the next-hop protocol address for a specific connection?

A. Frame Relay inverse ARP

B. static DLCI mapping

C. Frame Relay broadcast queue

D. dynamic DLCI mapping

Answer: A

Question: 18

Which statement is true about the PPP Session Phase of PPPoE?

A. PPP options are negotiated and authentication is not performed. Once the link setup is completed, PPPoE functions as a Layer 3 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.

B. PPP options are not negotiated and authentication is performed. Once the link setup is completed, PPPoE functions as a Layer 4 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.

C. PPP options are automatically enabled and authorization is performed. Once the link setup is completed, PPPoE functions as a Layer 2 encapsulation method that allows data to be encrypted over the PPP link within PPPoE headers.

D. PPP options are negotiated and authentication is performed. Once the link setup is completed, PPPoE functions as a Layer 2 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.

Answer: D

Question: 19

PPPoE is composed of which two phases?

A. Active Authentication Phase and PPP Session Phase

B. Passive Discovery Phase and PPP Session Phase

C. Active Authorization Phase and PPP Session Phase

D. Active Discovery Phase and PPP Session Phase

Answer: D

Question: 20

Which one statement is true?

A. Traffic from the 172.16.0.0/16 network will be blocked by the ACL.

B. The 10.0.0.0/8 network will not be advertised by Router B because the network statement for the 10.0.0.0/8 network is missing from Router B.

C. The 10.0.0.0/8 network will not be in the routing table on Router B.

D. Users on the 10.0.0.0/8 network can successfully ping users on the 192.168.5.0/24 network, but users on the 192.168.5.0/24 cannot successfully ping users on the 10.0.0.0/8 network.

E. Router B will not advertise the 10.0.0.0/8 network because it is blocked by the ACL.

Answer: E

Question: 21

A router with an interface that is configured with ipv6 address autoconfig also has a link-local address assigned. Which message is required to obtain a global unicast address when a router is present?

A. DHCPv6 request

B. router-advertisement

C. neighbor-solicitation

D. redirect

Answer: B

Question: 22

An engineer has configured a router to use EUI-64, and was asked to document the IPv6 address of the router. The router has the following interface parameters:

mac address C601.420F.0007

subnet 2001:DB8:0:1::/64

Which IPv6 addresses should the engineer add to the documentation?

A. 2001:DB8:0:1:C601:42FF:FE0F:7

B. 2001:DB8:0:1:FFFF:C601:420F:7

C. 2001:DB8:0:1:FE80:C601:420F:7

D. 2001:DB8:0:1:C601:42FE:800F:7

Answer: A

Question: 23

For security purposes, an IPv6 traffic filter was configured under various interfaces on the local router. However, shortly after implementing the traffic filter, OSPFv3 neighbor adjacencies were lost. What caused this issue?

A. The traffic filter is blocking all ICMPv6 traffic.

B. The global anycast address must be added to the traffic filter to allow OSPFv3 to work properly.

C. The link-local addresses that were used by OSPFv3 were explicitly denied, which caused the neighbor relationships to fail.

D. IPv6 traffic filtering can be implemented only on SVIs.

Answer: C

Question: 24

What is the purpose of the autonomous-system {autonomous-system-number} command?

A. It sets the EIGRP autonomous system number in a VRF.

B. It sets the BGP autonomous system number in a VRF.

C. It sets the global EIGRP autonomous system number.

D. It sets the global BGP autonomous system number.

Answer: A

Question: 25

What is the default OSPF hello interval on a Frame Relay point-to-point network?

A. 10

B. 20

C. 30

D. 40

Answer: A

Question: 26

Which command only announces the 1.2.3.0/24 network out of FastEthernet 0/0?

A. distribute list 1 out

B. distribute list 1 out FastEthernet0/0

C. distribute list 2 out

D. distribute list 2 out FastEthernet0/0

Answer: D

Question: 27

Which prefix is matched by the command ip prefix-list name permit 10.8.0.0/16 ge 24 le 24?

A. 10.9.1.0/24

B. 10.8.0.0/24

C. 10.8.0.0/16

D. 10.8.0.0/23

Answer: B

Question: 28

Router A and Router B are configured with IPv6 addressing and basic routing capabilities using OSPFv3. The networks that are advertised from Router A do not show up in Router B's routing table. After debugging IPv6 packets, the message "not a router" is found in the output. Why is the routing information not being learned by Router B?

A. OSPFv3 timers were adjusted for fast convergence.

B. The networks were not advertised properly under the OSPFv3 process.

C. An IPv6 traffic filter is blocking the networks from being learned via the Router B interface that is connected to Router A.

D. IPv6 unicast routing is not enabled on Router A or Router B.

Answer: D

Question: 29

After you review the output of the command show ipv6 interface brief, you see that several IPv6 addresses have the 16-bit hexadecimal value of "FFFE" inserted into the address. Based on this information, what do you conclude about these IPv6 addresses?

A. IEEE EUI-64 was implemented when assigning IPv6 addresses on the device.

B. The addresses were misconfigured and will not function as intended.

C. IPv6 addresses containing "FFFE" indicate that the address is reserved for multicast.

D. The IPv6 universal/local flag (bit 7) was flipped.

E. IPv6 unicast forwarding was enabled, but IPv6 Cisco Express Forwarding was disabled.

Answer: A

Question: 30

A packet capture log indicates that several router solicitation messages were sent from a local host on the IPv6 segment. What is the expected acknowledgment and its usage?

A. Router acknowledgment messages will be forwarded upstream, where the DHCP server will allocate addresses to the local host.

B. Routers on the IPv6 segment will respond with an advertisement that provides an external path from the local subnet, as well as certain data, such as prefix discovery.

C. Duplicate Address Detection will determine if any other local host is using the same IPv6 address for communication with the IPv6 routers on the segment.

D. All local host traffic will be redirected to the router with the lowest ICMPv6 signature, which is statically defined by the network administrator.

Answer: B

Test Information:

Total Questions: 430

Test Number: 300-101

Vendor Name: Cisco

Cert Name: Advanced Routing and Switching

Test Name: Implementing Cisco IP Routing (ROUTE v2.0)

Official Site: https://www.certschief.com/

For More Details: https://www.certschief.com/exam/300-101/

Effectively breezing through a critical test can be a tedious and repetitive process. Numerous hours of considering exam inquiries to breeze through a test are frequently expected to accomplish a passing score.